Clients using the settings shown above tend to change the location every few seconds or minutes.Īfter some troubleshooting, I discovered, how to circumvent that issue: In the first condition of location “Internal” I replaced the subnet entries by IP ranges and the “location flipping” ended. Index of /SEP/SymantecEndpointProtection14.3.0RU2FullInstallationEN/SEPM Setup.ini Symantec Endpoint Protection Manager.msi 1 06. Unfortunately, there seems to be a bug in SEP 14.2. Symantec Endpoint Protection Manager for versions earlier than 14 MP2 cannot correctly provide client versions later than 14.0. The location “External has no conditions at all, so it is active, whenever the conditions of location “Internal” are not met. So you don't have to worry about restarting the SEPM. Note: the second condition does not verify, whether the SEPM is available. If all IP addresses of the client are listed below:.The location “Internal” checks, whether the client has only private IP addresses configured and performs a NSLOOKUP to check, whether the DNS server is able to translate the SEP managers FQDN into a given IP address, which will most likely confirm, the client is in its own company’s environment: These Symantec Endpoint Protection (SEP) client-only patches allow you to upgrade a client from older versions of SEP 14 to SEP 14.2 RU2 MP1 (14.2.2.1). I usually configure two locations in order to detect, whether the client is onsite (internal) of offsite (external). The browser extension depends on IPS therefore, the IPS policy must be enabled and assigned to the group. The Symantec Endpoint Protection client blocks users from accessing malicious sites and redirects users to a default landing page. In most cases, this is used to raise the client’s firewall, when the machine leaves the company’s protected network and connects to the internet via any kind of public hotspot. provides better protection for both HTTP and HTTPS traffic to and from the Google Chrome web browser. Over the last years, SEP location awareness has been admin’s friend: It enables security admins to configure different security policies that are automatically applied to computers depending on their environment.
0 Comments
Leave a Reply. |